Start mode setting, drive mode setting, voltage level setting, controller limit value setting,Īll contents of the display screen (full display in boot 1S)ģ.1 Battery power and BMS residual power display Power switch control, wheel diameter setting, idle automatic hibernation time setting, backlight brightness setting, Speed display, power indicator, fault indication, total mileage, single mileage Note:The lead wire of some products uses the waterproof connector, and the user cannot see the lead color in the wire harness (1) working voltage: DC24V, 36V, 48V, 60V compatibility (instrument selection setting), Other voltages can be customized.Ĭonnected to the controller Meter outlet end To the terminal The shell of the product is ABS, and the liquid crystal transparent window is imported acrylic with high hardness, whose hardness is equivalent to the tempered glass. LCD-S866Hand Control Panel Operation Instruction If anyone has got any suggestions I would be very grateful. The wheel/motor shouldn't turn until the pedals are turned. I have tried connecting this to each of the controller I/P's in turn without any effect. Looking with a scope the blue wire has a steady +4v which gets broken into a square wave as the pedals are turned, the mark/space ratio changing as the pedals are turned faster. My bike hall effect transmitter only has 3 wires, +5v, ground and a blue wire. what is the controller expecting to see? The controller has a 6 pin connector for the hall effect, +5v, ground, and 4 wires marked sensor A,B,C,(D), (mine also has a white wire on pin 2). If I apply the brake the drawn current out of the PSU goes up, but if I actually stop the wheel the controller shuts down and I have to turn off/on to reset it.ĭoes anyone know what the hall effect wires actually do within the controller, i.e. However the speed changes as I press the "+" increase or "-" decrease buttons. My problem is that as soon as I turn on, the wheel/motor turns even without turning the pedals, and shorting the brake wires doesn't stop it. I also got an English version of the external wiring for the Brushless DC motor controller. Second:- I managed to get an English version of the operating instructions for the S866 which gives all the menu options. Warning the output is 18v with a 24v system so you need suitable bulbs or a high voltage to 5v converter to drive LED bulbs, don't know how much current it can supply as I haven't tried. To toggle lights on/off press and hold the "+" button. First:- The second 2 pin connector on the S866 LED reader is power for the lights.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |